Choose by Load, Motion, and Control
Start with the complete moving assembly. Include the camera, lens, housing, illuminator, adapter plate, fasteners, connectors, and moving cable in the load. Record the center of gravity as well as the total weight: a long or offset payload can apply more torque and inertia than a compact payload of the same weight. Keep the load close to the tilt axis and confirm the selected top-load or side-load arrangement.
Then match the motion to the viewing task. Continuous 360° pan supports uninterrupted horizontal rotation, but each model has its own tilt range. Low minimum speed helps with fine positioning; high maximum speed helps the head reach a new target quickly. Preset accuracy matters when the system must return to the same scene, while speed, acceleration, load inertia, and mounting stiffness affect how quickly the image settles.
After narrowing the motion range, match the electrical and site conditions. Confirm the supply voltage, communication interface, protocol, feedback requirements, temperature, humidity, rain exposure, wind, dust, corrosion, condensation, cable entry, and maintenance access. IP66 indicates dust-tight protection and resistance to powerful water jets. IP67 indicates dust-tight protection and protection against temporary immersion under specified test conditions. Neither rating establishes continuous-immersion, corrosion, or hazardous-location suitability, and the completed installation still depends on correctly sealed cable entries and joints.
Verify the shortlisted head with the actual payload, bracket, wiring, power supply, controller, and intended motion cycle. Maximum load and maximum speed are boundary specifications and should not be assumed to occur together without confirmation.
The BIT-PT409 is the compact choice here for a top load up to 17.6 lb (8 kg) and moderate movement speeds. The BIT-PT410 adds a 22.0 lb (10 kg) top-load rating, a 0.01°/s low-speed capability, and pan speeds up to 100°/s. The BIT-PT306, BIT-PT330L, and BIT-PT330S combine the pan-and-tilt mechanism with two side housings. The BIT-PT410HS combines high-speed motion with a top housing. For the BIT-PT306, BIT-PT330L, BIT-PT330S, and BIT-PT410HS, confirm the allowable configured load with BIT-CCTV using the installed devices, housing arrangement, center of gravity, and required motion profile.