One outdoor wireless security camera with pan and tilt may be enough for a warehouse gate and a loading bay if staff only need to check where a truck is waiting. If the site needs a record of what happened at both places at the same time, both need to stay in view. Try a fixed view that includes both areas. If it can’t show enough detail at each, give them separate views.
Look at What Drops Out of the Frame
When a single-lens camera turns from the gate toward the loading bay, the gate may disappear from the picture. It makes little difference whether someone moved the camera, a patrol schedule sent it to the next position, or the camera turned to follow a truck. The footage will show where the camera was looking at the time. A 360° coverage figure describes the area it can look across as it turns. To see how much it can capture at once, check the field of view.
Even if a fixed wide-angle camera can fit the gate and the bay in one frame, play back a truck arrival before settling on that position. You may be able to tell that a truck came through without being able to read its fleet number. Whether that matters depends on what staff need to establish from the footage later.
Work Out How the Camera Will Run and Record
If there’s power at the mounting point, Wi-Fi can save you a run of network cable. Where power is hard to reach, a battery model may be easier to install. Look at how staff would get to the camera to recharge it and whether there’s a suitable place for a solar panel.
Think about how staff will look up footage. If they need clips of detected activity, event recording may do the job. If they need to pull up a specific time in a shift, check that the camera can record continuously with the power and storage you’ll actually use. This is worth checking explicitly if you plan to run it on battery or save footage to a separate recorder.
Review the Sample Footage Before You Order
Start with a site plan. Mark the areas you need to keep in view and write down what someone reviewing the footage should be able to see at each one. Mount a sample at the proposed height and location, with the intended power supply, Wi-Fi, and storage.
Have someone walk through a critical area while the camera is pointed elsewhere. If they’re missing from the recording, try another mounting position or add a fixed view. For event recording, test the routes people and vehicles normally take, both in daylight and after dark. If a clip starts after someone has already passed the spot you need to see, adjust the position or detection settings and try again. If the camera still starts too late, consider continuous recording for that area.
Check that the live view and pan controls respond reliably from the proposed mounting point. If you also need footage during a connection outage, leave the camera powered and briefly interrupt the connection you need it to withstand. Once it’s back, try playing footage from the time it was down. If there’s a gap, test a different storage setup or camera before committing to the order.