Blue Icon (Tianjin) Technology Co., Ltd.
Blue Icon (Tianjin) Technology Co., Ltd.

Products

Contact Us

How to Connect PTZ Controller to a Serial Pan-Tilt Unit


The monitor already has a picture, and the joystick on the control keyboard pushes over, but the outdoor gimbal does not turn. On a split monitoring device, the camera and gimbal are two independent devices. When the picture reaches the monitor, it only means that the video is connected. To make the gimbal rotate, the commands issued by the controller must also reach the gimbal along the control line and be recognized by the gimbal.


Find the control port of the gimbal


Before connecting to the PTZ controller (how to connect ptz controller), first distinguish which device you want to control. To rotate the device horizontally or change the pitch angle, look for the control port of the gimbal body; to zoom the lens, look at the lens control method. The network-type BIT-PT540 has an RJ45 interface; whether it is compatible with the network controller in hand depends on the control methods supported on both ends.


Taking the BIT-PT410 as an example, its serial communication interface is RS485 or RS422. When connecting directly, press the actual interface of this gimbal to select the controller output; the two ends must match. The controller must also be able to issue gimbal-supported action commands, including level, pitch, and stop for trial transfers.


After the power is cut off, compare the wiring diagrams of both ends to see the respective sending, receiving, positive and negative ends and reference points. The terminal markings may be the same, but the polarity definitions may be different; do not move the RS485 connection method of another device directly to RS422. The wiring diagram does not specify short-term terminals; do not combine them together based on the markings.
image.png


Align command and serial port settings


RS485 and RS422 specify how signals are transmitted, while Pelco P and Pelco D specify how commands are written. Even if both ends are connected to the same serial interface, with one end sending Pelco P and the other end receiving Pelco D, they may still be uncontrollable. Installing a USB-to-serial adapter on your computer only solves the interface conversion problem and cannot automatically change the commands issued by the control software to protocols supported by the gimbal.


The controller is configured according to the current dialing settings of the gimbal: the actual address to which the command is sent to the gimbal, and the protocol and baud rate are also consistent with the gimbal. The BIT-PT410's DIP switch can set a device address of 1~255, select a protocol between Pelco P and Pelco D, and choose 2400, 4800, 9600, or 19200 bps. Address 1, Pelco D, 9600 bps in the manual are factory setup examples. When taking over an already configured gimbal, the actual dialing code shall prevail. The serial port also has data bits, check bits and stop bits. The baud rates are aligned and these items must be consistent.


Test transfer can verify which step


Before powering on for trial rotation, check whether the gimbal and the camera it is equipped with have enough space for movement. During the test turn, separate the horizontal and pitch directions. Walk a short distance at a low speed in each direction, observe the direction of the action, and then confirm individually whether the stop command is effective. The limits and the actual rotatable space must also be checked separately. It cannot be determined by a short-distance test rotation that there is no interference throughout the entire process. The self-test will be activated when powering on, which does not mean that the gimbal has received the command from the controller. If the self-test is normal but the joystick does not respond, return to the nuclear docking line on the gimbal control line side and compare the addresses, protocols and baud rates at both ends.


Level and pitch work, only the corresponding gimbal commands are verified. If the lens cannot zoom or focus, you can check the lens control line and verify that both the control end and the controlled device support the required lens commands.


Related Articles

We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. Part of the tracking is necessary to ensure SEO effectiveness,
By using this site, you agree to our use of cookies. Visit our cookie policy to learn more.
Reject Accept